Hi James
Checked again with the calipers and my memory was correct the bearings are 4mm width from outside of one surface to the other so they are just a regular bearing. My RPM hubs are going to go onto one of the tubs that Stephen is going to send me, the vintage tub I have here is going to be the runner
I also picked up another real cool part which is a pair of Team Atlas blue anodised steering posts, new in packet. The have a wider section part way up the shaft so you don't need the lower spacer from the steering parts, not sure if they should go on the 21st Century Mid or the above mentioned tun that will get the RPM parts.
I appreciate you following up with Stephen, he has mentioned the situation to me in email but the last couple weeks he has not been responding to emails, I suspect they are super busy or maybe he has had to take some time off work
__________________
___________________
Maxxum FF
Ultima Pro
Turbo Optima Mid SE
Turbo Optima Mid SP
Optima Mid Custom Special
Lazer ZX
Lazer ZX-R
Lazer ZX-S
|