Quote:
Originally Posted by Optima4Ever
I assembled the buttons on the wire, indeed very tricky, but the 90 degree bend in the wire didn't allow sliding it through. To be able to assemble the top and bottom parts, the top part needs to be inserted at a slight angle. So I chamfered a side of the part that snaps into the bottom half, so with a little push, it could pop back into the bottom half, even when inserted at a slight angle. I think if you can assemble this, you can assemble about any vintage RC car, right? ;-)
|
Yes - it does seem that it would be impossible to get the wire/buttons to slide over the 90deg bend - but you kinda have to rotate the wire with a little more force than seems comfortable - but they do go!
- once you get the hang of it, it actually is quite an easy assembly!