View Single Post
  #15  
Old 02-07-2014
robin_c robin_c is offline
Member
 
Join Date: May 2014
Posts: 43
Default

Right then 3D + 2D cad 90% completed. Just need some diffs and washers to do the check dimensions and sort tolerance stacks.

I will cad up and make the washers too. Guessing these will be a harder material than the alloy diffs, probably a stainless steel.

Cost depending I will probably get a fair few extra made as nobody seems to sell these any more. I will obviously sort out whoever lends / sells me the set.

Once these are done I can start to look at replicating all the other alloy wasp parts for Procat / Bosscat etc.

http://www.oople.com/forums/attachme...1&d=1404319157
Attached Images
File Type: jpg diff cad.jpg (142.9 KB, 34 views)
Reply With Quote