Even though I've just been singing the praises of this speedo on another thread I do have one little problem with it. I can't get mine to ccalibrate! Get to the throttle calibration and get beep beep but come to do the brake and nothing. Just unresponsive. Have to switch off and switch back on. Not as major problem as it could be as I've set my throttle and brake end points to 140% and 115% and am getting full throttle and brake ie LED goes solid green. Neutral point is correct as well as if I tinker with the throttle trim it's slap bang in middle of dead zone at 0 trim.
So not major issue but does irk me slightly. Anyone have similar issues or a solution? Have re flashed latest firmware etc
|