Quote:
Originally Posted by alcyon
My 0 degree caster C hubs with ball bearings are ready.
Designed to be used with standard ZX-5 Knuckles LA-219-4 or LA-219-7, and with use of original kingpins. However because
the height of the C hub is much higher than LA-27, the LA 245 CVD bone will interfere with the gear diff bevel gear output shaft, so you need to shim the CVD on the outside, not the inside. This will push the CVD out and it wont interfere with the bevel gear output shaft. |
Where can I ask did you get those turnbuckle from I had a red set in a old dog fighter and have been looking for some more