Hi, firstly thanks for your first reply,
I've put the stock 1 software on it instead of stock 0 and it's the same, I've put all brake options to max,
Initial brake 60% which is max,
Drag brake to 80% which is max,
Brake force 100% which is max,
When I run the car flat out on my lap then let go of throttle the wheels stop very quick and hard,
When I run the car on the floor it will carry on when I let go of throttle until it stops which distance varies depending on speed car was going,
If I just tap the throttle to set the car going and instantly let go of throttle it takes about 4 feet to stop even with brakes maxed out,
I have calibrated the esc to my controller after every firmware change and every change done on the lcd programme box.
The controller used is a 3vcs and I have reset one of the models and done the throttle reverse channel and epa at 100%.
My servo is a savox sc - 1251mg.
My car is a 1 cell supastox running 6000mah lipos
|