Hi Nigel
I've had that problem before with the speed passion motors. The wire came off due to a poor contact on the motor cause the connection to heat up. Check the plugs if they pull off easily then replace all three of the springs on the motor contacts.
To replace them you'll need some male 3.5mm bullet connectors and carefully remove the springs without bending them. Then remove the back plate off the motor and the old springs, then push the new springs on the pins.
The best way to do this is clamp the donor connector in a vice pointing up and open the spring slightly with a small screwdriver and slide it up off the end of the connector. Then holding the with the pins pointing up push the springs down onto the pins.
I hope that make sense. I can post some pictures if you that will help
__________________
Team Xtreme Predator X11, Associated b64d, Associated b6.2d, Arc A10, Awesomatix A12, Xray NT1.3
|