Quote:
Originally Posted by alcyon
Welshy40, the holes at the front arms are required to clear the outdrives in case of maximum arm travel. Ok I will get yours cut out to fit the wheel retainers but I will leave mine as it is. Also I looked at LA-27 and there does not seem to be a left or right side, both angles look at zero. Its the arms inner pivot to the brace to the gearbox that is producing the angle, am I right or wrong ?Cause I really cant see any angle in the C hubs, unless its LA-59 which has the inner holes drilled at and angle.
I just rechecked the ZX and ZXR manual, LA 27 C hubs do not have a left and right version, only the knuckles.
|
The hubs actually have angle on, if your looking at the blue team line ones you can clearly see the angle in pivot pin hole through the hub. Kick up I am unsure what that does to the overall angle but my hubs say 5 or 7.5 on them and havent ever seen a zero for this car.
Wishbones, what I meant was the pivot pin holder had a little u section which was for an adaptor to bolt the wishobone to the pivot pin meaning it would not move or have slop due to that and is what I currently use. I will post a picture so you understand.