Sway bar mounted Asso silver (Asso bar bent to 45deg. - mounted on the rear right above the rear bulkhead and underneath the rear shock stay/wing holder using cable binders through the outside hole of the reardamper to fix - hole drilled on the rear of the suspension arm). This works with the genuine rear shock stay and small modifications but without hurting the shock stay.
Alternatively you can use a Tamiya DT02 sway bar set and mount it the same way as described
If you have an Atomic Carbon or similar shock stay (it is important that the screws connecting the shock stay to the bulkhead are not sunk as with the genuine shock stay / or you will have to level out) you can use the upper or lower screws to fix the sway bar of an e.g. Cyclone Touring Car version sway bar mount on the battery side of the rear tower. Off course you will have to fit a bar on your own.
Best working solution is of course # 3
|