Cheers for all the replies. It's good to know people are getting results they are happy with. I will fit it and see
The concept makes a lot sense, I was just surprised that on all of the setup sheets from the Likes of Cockeril, Moss and other EU team drivers setups on petit rc there was no mention of them being used (and as such no guidance to settings on different track surfaces).
Our tracks are both high bite but one is smooth indoor carpet the other is relatively bumpy astro turf, any starting points on settings for these conditions?
Chris - I had read the issue regarding the pin moving if the system was set loose. So are you putting very thin heat shrink actually on the pin itself or around the housing the pin goes through? I read about using the inside ring from a bearing around the housing as a solution.