Next prototype off the cnc this afternoon are 7075 T6 alloy chassis for the GTB
. This again is just a basic rough prototype with minimal finishing (a light sanding with 1500 & 3000grit). I will be fitting it on my car and testing it at the weekend.
I'm unsure what the flex level will be, but if I find I need more flex we are prepared to start milling pockets out of the top side . This could also have add benefits of allowing me to lower the full electrics install in places reducing cog. We are looking at the process of hard anodizing them in house as well but we will see about this.
I have not had a chance to accurately weigh all the new parts but safe to say the alloy components could add a bit of much needed weight low down.
If there was interest in these we would be looking to sell them at a very reasonable price somewhere around £25.