Quote:
|
Originally Posted by hickston
Theres an addendum missing from the scanned version which I dont think you've included..I dont have a scanner, but basically, Step D-02 is
- Install the Differntial with the Diff Nut towards the motor Plate
- The diff ring shims installed in the previous step are optional. if you choose not to use them (see setup guide), you must install two additional smaller diff shims on the outside of the diff before installing the diff into the gearbox case. NOTE YOU MUIST RUN AT LEAST TWO OF THESE SHIMS AS SHOWN.
Phew. I followed the first point and basically it makes adjusting the diff even more difficult than before. (or maybe I should read the rest of the manual).
Ta
Stu |
its in the normal manual page 12