Quote:
Originally Posted by Toonz
this was what i've done today...
install slipper, replace all the screws with titanium (so many screws again!), put in a tamiya BZ23T motor and gear up to the max 23pinion....
ran it, stupid fast! hahahaha.......and melted part of the lousy rubber connector cover between the motor and esc. the rest of the units are fine. need some deans i guess....and to gear it down...i'll try the 17pinion tomorrow...
does any of you feel that the front arms wobble more than the rear? the manual say 2pcs of 3x0.2mm shims for each side but i've added 1 more tonight and it feels better.
|
I've shimmed my arms out to be virtually slop-free but still smooth, needed 0.5mm+ on all the arms plus a few small shims at the hub carriers too.
It is just a habit I have got into over the years.