If you cut off the uprights that normally the pin fits through. then drill a 3mm hole in the same area through the flat part where the upright used to be. you should already have the holes in the wing. then use m3 or similar bolts with a washer to go through the wing into the wing mount and then use a m3 locking nut to clamp it all together.
__________________
Current rides N slides and flies sponsored by
http://www.westernvalleymodels.co.uk/
- TLR 22-4
- TEAM C TM4
- LOSI MINI 8 FULLY HOPPED UP
- GT12 S1
- HPI FIRE STORM
- TRAXXAS KEN BLOCK GYMKANHA
- Carisma Nissan Skyline GT
- DJI P3
- FIRDBIRD STRATOS
|