yes I have read the esc output with ac.across the 3 wires is equal 10.7v ac drawing 1.7amp no load.i have reset the esc and made sure of low volts cut off and I have adjusted the timing mode (3 different ones).low is 9500 and high being 9800.jus when theres a load it runs a 4750.should it be 14.8 nominal from esc to motor,and ive only got 10.7. one thing I haven't checked is the capacitors.if one has gone would this give a lower volts to motor from esc.?
__________________
Current rides N slides and flies sponsored by
http://www.westernvalleymodels.co.uk/
- TLR 22-4
- TEAM C TM4
- LOSI MINI 8 FULLY HOPPED UP
- GT12 S1
- HPI FIRE STORM
- TRAXXAS KEN BLOCK GYMKANHA
- Carisma Nissan Skyline GT
- DJI P3
- FIRDBIRD STRATOS
|