A very valid question, there is little information on this... So I decided to buy an RDRP LRC RF Hanger a few months back: It turned out it was the same geometry as the plastic 0 degree anti-squat hanger from the DEX210 kit.
I returned it because I actually wanted the RF hanger lower too you need the
Exotek LRC RF Hanger, which is actually up to 2mm lower than the kit standard.
So to answer your question: The 3 degrees RR hanger from the RDRP LRC Kit+LRC RF Hanger gives the same geometry as the Durango -2mm RR Hanger+0 Degree Anti-Squat RF Hanger. So you just need to change the RR Hanger really, and these are offered by TD, RDRP (some retailers sell the hangers seperately), Exotek and Tresrey.
If you look at pictures of the upcoming DEX210V2, you will notice that not only does it have that -2mm RR hanger, it also has no shims beneith the inner rear ball stud - it's a complicated story, but using no shims under the inner ball stud should prove a good starting point
