I've fitted the triad to mine too. Not had the chance to run it yet. I did have a couple of issues. Following the exact instructions on the petite website did not work for me. The shaft was not long enough to fit the end washer and nut. I did not pay close attention to the fact that the instructions were for the original bmax2 not the mr. So I took it apart and addrd more washers to the other end of the shaft that fits to the bearing so you have 1.00 mm. I then replaced the avid bearing spacer ( the first piece you put on during slipper assembly) with a lower profile spacer from the b44 slipper. Part number as9726 I was then able to assemble without any problems.
|