me personally ive had great success by hitting the nearest size torque in there.i have a selection of torque bits,as the sides of the torque bits are sharper they tend to 'cut' or 'dig' in and stay in enough to loosen it off
like these
http://upload.wikimedia.org/wikipedi...20-T25-T30.jpg
hope this helps good luck
__________________
_____________________________________________
Kyosho TF2 Kyosho TF3 Kyosho TF4-R
Kyosho Lazer ZX-R Mk2 Kyosho ZXR Kyosho zx
Kyosho Lazer 2000 (with zx parts)
Atomic CR2 SCT
_______________________________________________
Trader Feedback thread
|