Quote:
Originally Posted by RogerM
Definitely 2deg with no spacers under either RF or RR blocks.
Shims are 0.5mm thick which equates to 0.75deg per shim (1.5deg per mm) - if you want to get really accurate it's actually moves between 0.71 & 0.78deg due to the swept angle changing too but most people use 0.75 without issue 
Same for the ZX5 as the hinge pin holder / wishbone width is the same, see FABs sheet on Petit Lazer setups section
Hope that helps. |
Hi Roger
What's the max you can run under the rear mount for instance could you run 1mm under the RF and 1.5 under the RR, this would give a slightly higher roll center and less squat than kit approx 1.25deg?? (if read correct)
also not related to squat settings but if you move the rear inboard arm shim to the rear how will this change the car we are talking MM set up
Thanks in advance