[neallewis]

Originally Posted by Rstephenson

Hi guys i just got a second hand ko propo esprit 2 i got it with a broken
fr`sky vbr4-2 receiver i bought a new receiver i have no idea how to sync the 2 together?? also the receiver wire looks really small is this the recommended receiver
hope you guys can recommend
cheers guys

1. Find the bind button on your TX hack module. Power up TX with the button pressed. LED (Orange i think) will flash continuously.

2. Power up RX with the F/S button held in. This will place the receiver into bind mode. They should bind after a few seconds. leave it 10-15, then power down both.

3. Power both up again and you should have a bind.

4. Pressing the F/S button once powered up will set the failsafe. Do this with sticks in neutral once you have calibrated your ESC and set your servo up. It means you can turn of the TX and the car will just sit there waiting for TX, rather than flying off at full pelt.


Frsky data:
http://www.t9hobbysport.com/frsky-v8...annel-receiver
http://www.t9hobbysport.com/frsky-dh...try-diy-module
You want non-telemtry modes.