Next up is the battery stopper. This fixes to the chassis with two M3x8 flat heads.
Building the swinging battery cover is next on the bill. A little cutting & trimming the spru first!
After cleaning up the cover mount, slide an M3x10 though the battery cover & though a flanged tube into the cover mount.
Battery tray foam in next.
I opted to fit both centre & side foams.
Next locate a square peg in a square hole!
Bolt down your hinged battery cover with two M3x8 screws
Locate the mid motor conversion battery post mounts & screw them into place with two M3x22 screws. The screws that came with my kit
were more like M3x25's
Push the cover into place......................
Bolt down the battery cover with the two supplied thumb screws. I'll upgrade the thumb screws to alloy one's at a later date!