Quote:
Originally Posted by Voske
Looks like a very nice kit, and a nice build threat.  |
It's been a great kit so far. No grumbles from me!
Right up next is the front hubs. Again all nice clean!
Push in the two M5x10 included bearings
Screw in a 4.8mm ball stud.
Push the knuckle are pins through the knuckle arms.
Place a M5x02 shim over the knuckle arm, then a hex adaptor.
Then secure with a M2x12 hub pin.
Take your knuckles and & place in the C-hub with an M2.5x7x1 plastic spacer each side of the knuckle. Push pin though &
Secure with a M2x4 button head screw.
Left & right hubs finished
Next up...........turnbuckles!
I always take a little bit of plastic out of the ends of the ball caps just for ease of starting them off!
The supplied tool helps lots! Make four up & put them a side ready for mounting!
Time to mount the C-hub/knuckle assembly.
Two spacers each side of the c-hub, push pin though & secure with a M2x4 screw.
Snap on you four turnbuckles and there you go!