Quote:
Originally Posted by AfroP
Just at the electrics/servo install part of my B44.2 and so far everything has run smoothly
but when i get to the bit for installing the servo,I cannot get a kit supplied servo horn to fit.
Normally for a savox servo i use a 25t or Futaba horn, but the kit supplied futaba horn is either too small or too tight of a fit to actually go on my servo.
has anybody else had this issue?
any advice would be appreciated
thanks
|
They are very tight!
Put the first bit on then screw it on ensuring the threads are lined up
You will also need to trim some plastic off the casing so the arm doesn't hit it potentially
Fit and try and then remove and mod