Quote:
Originally Posted by mikeyscott
Can the yokomo take hex wheels all round? Got a load of Kyosho wheels
|
Not out of the box no...rear is pin, front is metric shaft/bearings.
I suspect you could probably get hex adapters to fit though...there is a front axle replacement that take you to AE bearing size...which would then allow you to use one of the AE hex adapters up front...I think a couple of manufacturers make those adapters now too. Not sure on rears, but suspect you could find something to do the job!
I have my old stocks of AE wheels, so not had to look into that one.