[rcjunky]

to run the VTS, you shave down the hex part of the basket just a tiny bit so it fits in the spur, then drill the outer plate and make a slot to fit the head/pin of the durango long pin. You then drill it just a bit after you hit the shoulder on the plate (I was holding the piece and using a drill press, once it caught and just spun it out of my hands, I needed to go a bit further) then use the stock spring and washers, with the new durango layshaft spacer of course, and you're good to go, and you need to cut the center of the gear cover out, just a bit bigger then the slightly raise section on the stocker. I plan on modding a second gear cover to cover the VTS unit if needed which is unlikely. It looks like the new dex210v2 will have a different tranny, its scheduled to come out in February.