A bit more digging and the following is my solution, all Yokomo parts.
ZC206MH are 6mm in length the same as the Kyosho short
ZC206LH are 8mm in length the same as the Kyosho long
Both snap nicely into the Kyosho ball cups.
Unfortunately I believe the ball height is slightly different so you will either have to compensate with the shims or swap the outer balls too.
1 pack of each (6 ball studs in a pack) are enough to do both a ZX5 and RB5 assuming your going to corect the height with the shims.
4 x MH at the inboard positions on the ZX5
2 x MH for the outer front link positions on the ZX5
2 x LH for the outer rear link positions on the ZX5
The remaining 4 x LH studs on both ends of the rear link on the RB5.
Thanks to all those that have made suggestions, much appreciated.
|