Ok guys an update.
Chassis has been made, asd per my previous picture, now a rough cut before the finishing off. Holes have been drilled and cell holes now to come along with the motor section cut away and the corner side wall hole being drilled as well. Proto will have a 24mm high side wall so hope its not too high as my original first chassis had 23mm. FYI you can have the chassis cut whichever way you want and for shelfers you can have it made exactly like in the pictures obviously it will be finioshed properly before you get it. For shelfers the motor cut away wont really be needed, well in my opinion anyway.
As you can see the lipo tray design has been cut and put on the chassis for you to see what it will look like.
Also the shock tower is what i will be using and as you all know have modified the original design with more strength at the bottom strut. This one has been changed to fit my design front gearbox that Oosh123 made for me.
Then the last item the little brackets, ok I am having a few made but will not be made as they are difficult to make. Once I have tested I will be selling with bearings and the screws and bits need to basically fit to your gearboxes, ok after ive made a manual on how to do it so all can then race without the fear of snapping the rear belts.
Let me know your thoughts on this.
|