Quote:
Originally Posted by OneKiwi
I have some 4mm GRP so I might try this and I have an extra chassis I can cut up... maybe even the stock chassis kick up
|
If you decide to make your own, a little trick I figured out is to hold the original chassis against the FRP and use it as a guide for drilling the holes. Put a bolt in the first hole you drill, then drill another hole on the opposite corner and bolt that one. Then you can drill all your holes without worrying about your guide moving while you drill. It worked pretty well. Just don't do what I did and try to use a bigger bit to countersink the holes. Either use button head screws or buy an actual counter sinking bit. I also cut the nose off my stock chassis flush with the front of the weight cutout.