With the dimec chassis would it be possible to epoxy a 2mm thick, 50mm wide strip of CF (or GF) along the centre of the chassis, under where the battery sits? There should (i think) be a bit of a gap anyway due to the length of the battery and the shape of the side pods. This should stiffen it up nicely.
I've just made the decision to strip my RTR down and stick to one car, so what i'll probably do once it is stripped is use that chassis to try a transverse battery before i dismantle it. Then i've at least got the chassis to use again if its any good! (or i can replicate it on the RDRP car i'm also running.....)
|