Quote:
Originally Posted by PaulUpton
Going to throw my neck out but......on the underside shot there is what looks to be a hole where motor sits ie to get motor lower. This is running length ways front to back, which would suggest motor is too so pinion at back end bell at front which would indicate shaft drive?
|
If that hole is under the motor then they are using the motor from the Micro-T. Look at the first picture, you can see the layshaft sticking out of the body and the body shaped over the spur gear, just like the XX4.
As the XX4 still works so well there's not much point starting all over again with the chassis layout.