Quote:
Originally Posted by diago999
Delves, what does the tiny little grub screw (TLR6289) that goes into the aluminum front pivot block on page 17 do?
also congratulations on the new layout, (rear motor and then mid motor) much easier to read through 
Question, can anyone see any issues with using saddles side by side with this new motor brace/battery compartment/flap bit and just using some foam to pad out the end, or modifying it so the post is moved closer? |
This screw holds the block in position when you take the gearbox out. With the current car when you remove the gearbox in mid configuration the front suspension carrier moves about and inevitably the wishbones pop out. So this screw will eliminate that happening. Not performance enhancing but certainly makes working on the car easier.