Quote:
Originally Posted by Welshy40
There is a grey bushing in the central spur gear hole. There is a bushing in the hub going into the motor plate. Theres two options between the layshaft pulleys, i prefer the thrust washer to a solid bearing but the bearing does work just as well. So for a bearing measure the inner thrust plare washers inner hole and also the outer diameter in mm's and then you should be able to find a bearing. Be warned you may find the bearing works better without the e clip on the layshaft
|
Hi Welshy. I
Forgot to mention them bushings, They are in my build. have i done the thrust bearing part correct? With the two 1.5 washers either side of the thrust bearing? Thats the part im unsure about and is not shown in manual .
Thanks for the replys
