Quote:
Originally Posted by alcyon
Problem is if you want to use the B4 slipper, the VTS parts wont line up, and vice versa. Its best I only make 1 type of layshaft to save cost, so I guess we have to with welshy preference which VTS then I guess I will make only VTS version. For the optima mid however, it will the B4 standard slipper.
|
No, by extending the threaded section out by another 2.75 to the end of the last design slipper at the side of the layshaft the B4 slipper should fit perfectly. The VTS slipper is basically based around a B4 slipper so will fit perfectly on this shaft. I should get a definite within two weeks.
My last design was to move the slipper plate closer to the motor plate so the gear cover gave plenty of room for use of the VTS, i did make a mistake in my measurements amd turned out i was 2.75mm too short at the slipper threaded end so was off a bit. My fault but we are at the end of testing and just need confirmation shortly to see if its a perfect fit for both slippers.