Not sure if you guys check out the rc tech thread's.
It's easier to just shoot the link than re-post.
http://www.rctech.net/forum/12260782-post11412.html
This swap took about 20 min to do.
I just had to ream out the a-arm hole to 3mm.
I have not measured width yet..but my eye-o-meter says it's the same.
No idea if it's going to work...just wanted to try it out for the hell of it.
You can buy AE parts
everywhere over here (my hobby shop is stocked) so if it works it might be advantageous.
Are the dropped arms preferred for low ride height..or is it better to have a straight arm?