Hi Tony
Our car in the advert has no post at all
And looks really sleek
It Just has some Velcro attached on the carbon sides but not covering the screws that hold the carbon sides on and still uses the front mount and clip.
I find it easier to fit the front body clip if you bend the clip to an arc with some long nose pliers.
You could use the standard rear mount by reaming the front hole further forwards from the mark in shell but to be honest I've never liked that Durango rear mount due to it being too close to the rear edge of the shell , so they always rip.
Plus using the rear mount makes the DARC shell look to porky!
Hope this helps Tony
For any non DARC owners reading this I will explain
The DARC shell has cut lines front and rear also front body mount hole and ariel marks
But no cut lines for the sides
So therefore you can install your radio gear the cut out front and rear on the shell, then place on the car until you are happy with the radio gear clearance .
Then trim the shell sides level with the chassis bottom edge. Velcro on.
This allows for larger speedos etc
Hope this makes sense
|