Thread: Set up
View Single Post
  #2  
Old 01-06-2013
blue_pinky's Avatar
blue_pinky blue_pinky is offline
Mad Member
 
Join Date: Aug 2007
Location: Weston-super-Mare
Posts: 1,625
Default

Hi,

I used to run a B44.1...but don't have a full setup written down, so as a starting point:

Front
35wt AE oil
Silver springs
Shocks mounted inside hole at the top, outside hole at the bottom.

Rear
30wt AE oil
Green springs
Shocks mounted inside hole at the top, inside hole at the bottom.

Ride height with drive shafts level, maybe a touch higher.

Tyres would be either Schumacher Yellows or Ballistic Whites in the dry,

Weight was just the AE ballast weight that fits between the cells...think it's about 70g ish?

I had the camber links mounted with a couple of washers under the inner studs (lowering them) at the front and rear, and it set in short wheelbase from it's last outing.

That should be pretty close as a base to work from, hope that helps a little.
__________________
AKA: Andy Nancollis
1/10th drives: Yokomo BMax2MR & BMax4
1/16th drive: Carisma GTB
Racing in South West: http://www.mendiprcraceway.co.uk/
Racing in Wales: www.caldicotrcracers.co.uk
Kept running by: Yokomo via MB Models & www.tracksidespares.co.uk
Shells by Square Crabs
Reply With Quote