Just done this, only issue is with the length of the slipper shaft (its about 5mm too short, i've trimmed the spring a bit) and the notch that runs on the other shaft (can't remember its name! But the AE one is about 0,5mm narrower than the TD one, needs dremelling out to allow the shaft to fit).
All works fairly well so far, think i need another 10 minutes of dremelling as i can't quite get the slipper tight enough, think it might be binding somewhere i've already dremelled! (But obviously not quite enough!)
Will have a first drive tonight, unless it rains.
|