[Cremegg]

Hi

Run an speed passion gt2.0 pro esc and alturn servo

Ive recently purchased a new mrt pt but the loop at our club is picking up a very weak signal, and it only picks it up if it is rubbed over the loop (0 mm off the ground)

My lvc was set to 3.4 and I was having trouble with my steering glitching at not getting full power (on and off this was happening),

I changed this setting to 3.0 and now the power and servo work flawlessley.

Unfortunately the loop was put away by the time I was able to test if the pt would now work better

Could this of been the reason why I was getting no signal from the pt? As not enough voltage was getting to the pt


Thanks