Quote:
Originally Posted by mark christopher
Sounds like a sensor issue either lead or board
|
It is an odd 1 that because I think it would also have issues in blinky if there was issues with the sensor.
I think what I'd do is set no timing/boost in normal mode and see how it runs (ie not blinky mode)
Then add timing in small incrememnts. If it doesnt work right with the first increment then something is clearly wrong. It may be that your just giving it too much timing/boost.
On my tekin system, I could add timing no problem, but If I added turbo (which I havnt, but is similar to how I think boost works on yours) the motor definately wouldn't like it.
Also check where the endbell timing is set. Wind that back a bit too if its up high.
Hope this helps. I'm just using trial and error here, I have no experience with this esc/motor combo