Quote:
Originally Posted by Darren Boyle
HI Ant, yes the inner rear ballstuds will be "vertical" on the production spec car (shown horizontal in the pictures) so you can adjust the ballstud height infinitely with shims/washers (like the front)
Battery movement was a key feature and you do not need to purchase any extra parts or alternative fancy battery retainers to be able to do it.
|
Thanks, it would be good if the lowest position (no washers) was, say, 2-3mm lower than the X6 sq. I run without e-speed hangers on the outside hole with 1mm removed, but would run lower if I could to tie the rear end down more and avoid using a rear bar. This is approx. the geometry most people run on the Centro. Just my 2p worth with the best intentions!