Here is the picture. Module has been put in with the plug section on the left and is at an angle infront of the circuit board and sits under the aerial. The aerial is sitting ontop and then ive diverted into the wire divider sections and this avoids the aerial touching any metal.
I drilled all the way through on the aerial hole but fits snuggly, however is a bit tricky to do the inner nut to stop play but once you have the right amount it fits really well.
I also bought a battery from Hobby stores and was a bit expensive but is one that holds its power, and fits perfectly, howvwer if you do this make sure you move the wires around to avoid a short as the futaba connectors are wired differently on the batteries compared to the Sanwa design.
|