Quote:
Originally Posted by Dazzler
3.5mm connectors are fine, the bit that goes loose is the spring part of the connector on the male side in the motor. If you get the 3.5mm pairs you have, then carefully pick the spring part of the connector off of the new male connector, then remove the back plate of your motor and swap them all out, you'll be good to go. It's the springs which are going weak..
|
Hi Dazzler - yep - i've done that trick before.
I did though measure the Speedpassion plugs internal diameter and it's 3.4 (ish) whereas the third party plugs I bought have an internal diameter of 3.6 ! They were sold as 3.5mm plugs, but I guess they are a sniff bigger to accommodate the spring plug....