Quote:
Originally Posted by eddscott
Is it possible to do the same conversion to a Esprit III ? I did it on a II no problem.
Also, I notice the new modules have a little switch - what do you do with that?
|
Yup, the esprit 3 converts perfectly. you can hide the hack module in the space behind the module slot, if you remove the data board that't behind it. just use the three pin lead that goes to the original module pins and solder it to the new hack module and plug it into the main board. The bind daughter board sits lovely behind the data/model expansion slot on the back, just hot glue it in.
The new modules come with the 1-way/2way selection switch. Just remove this and solder the pins on the reverse side of the white 3 pin connector, to set it permanently to 1-way. You don't need the telemetry feature. buzz it out yourself so you are sure, but its the outer most two pins that you need to short, leaving the 3rd inner most pin on its own.
I'm just working on putting one inside a Ko RF-901S module case, so a transmitter can be left as standard, but still use the hack module.