Guys,
Here it is almost ready to go out and play.
*Ceramic diff balls,
*Ceramic thrust race,
*Ceramic diff bearings,
*Ceramic layshaft bearings,
*New bearings in the hubs,
*New rebuildable Ujs front and rear,
*New front gearbox with an amendment to the original design Oosh123 and I discussed and built to the CF side plates so I don't have to rebuild the diffs every time I want to take it apart so also uses normal sized bearings on the diffs and not flanged bearings.
*Lunsford Titanium tie rods
*Associated touring car ball joints and ball cups (also used on the RC10B2).
*My new designed and finished rear CF gear box
*New Alloy motor plate curtousely of Oosh123
*My new Alloy rear top deck mount which is 3mm higher than the standard one (just the top deck mount holes) to give room for me being able to use 5500 Lipo packs.
*My Lipo tray design
*Servo further inboard
*My top desk design but will be modded again to give more strength for this front gearbox
and various other mods that you'll notice like thicker rear tower, centre block on chassis, weight on top of it and weight behind the rear tower, plus the rar hubs are from the ZXS Evo, front knuckle arms from the ZX, steering plate from the ZX, etc etc
Enjoy.
|