Quote:
Originally Posted by Fredrik Emilsson
Thanks guys!
Nice to hear that you like them.
This is one of the reasons I do this, there are so many nice people out there. 
Thanks again! |
No problem. I like the design (I had the original long ones previously) and the interchangeable left/right belt setup.
I had to shave about 1-1.5mm off the top of the front upper cover to allow the shock tower to clear but that was easy and there's heaps of material up there so no worries.
Note to all - ream out the screw holes before you mount - I didn't and cracked a piece. My bad and no major problem but at least it can be a lesson for you all.
Pics tomorrow.
Edit: so of course one needs to disassemble to install these and I took the opportunity to check and rebuild my diffs (as I need to drop the front gear diff down to 7k from 10k). Both front and rear were really quite dirty and that's after 8 packs with compressed air blown through them before each run (hard pack track, astro track and some grass/snow bashing as well). Basically the stock setup is ridiculously exposed.
You need these covers.