Quote:
Originally Posted by RichyUK
They look good, i actually made plates exactly the same out of some 0.9mm stainless plate. You may have an issue with the MM ones, i made mine pretty much the same shape, but as you don't use the 2 central holes nearest the front of the plate in MM, only the 2 slightly further back, i found i caught the front edge of the plate and bent it up badly as the support from the 2 screws is too far away from that edge, if that makes sense? I will probably chop mine back to sit much closer to those 2 screws to prevent it catching.
|
No, it makes sense. I will keep that in mind, thanks. As mentioned haven't really ran into any problem as we mostly run RM and the support goes right to the end of the plate. Thanks again for the heads up!