Quote:
Originally Posted by forbesy
ive just rebuilt my diff in my db1 using new diff plates, new gears, new thrust race, new ceramic rudebits balls, but it doesnt want to stop slipping untill i do it up tight which i havent done as i thought it would snap the thrust race!! ive ran it in twice too but that really hasnt helped 
any ideas pls chaps......... |
i have had this issue but what i found was that backing off the screw the tinnest amount make a difference to adjusting the diff i initially backed off the the diff 1/4 of a turn and it felt like it would fall apart so i tightened it up fully and backed off in very small amounts until it felt ok i bet in the end it was backed off about a 1/4 of a 1/4 of a turn if that makes any sense , oh this was on a rb6 which i believe is the same diff if so then try that. They do seem very sensitive but very smooth