Quote:
Originally Posted by Origineelreclamebord
I had a look at the Xray XB4 CVDs, however, they are actually shorter than the Tamiyas (strange being that they actually say '68mm'), and the head that goes in the outdrive has too big a diameter to fit. So, TRF201 Driveshafts it is!
 |
After reading your more recent posts, you may find the following measurements helpful. Using the labels shown at the link below:
http://www.rc10talk.com/download/fil...7892&mode=view
Some corresponding approximate measurements in millimeters are listed here. Where ball diameter is the "head that goes in the outdrive"
Kyosho LA231-01 (A=9.75 B=68 J=2.0 with ball diameter 5.89 and axle cross pin used 2.0mm)
Schumacher U1915 (A=11.8 B=68 J=2.5)
Schumacher U2683 (A=11.8 B=70 J=2.5 with ball diameter 6.96 and axle cross pin used 1.5mm)
Unmeasured
XRAY 365320 with106051(according to manufacturer specification listed A=12 B=68 J=3.0)
Also I think the wheels used for the Kyosho and Schumacher axles listed, have 4mm hole diameters while the Xray and the Team Durango rear wheels may have 5mm diameter holes. Perhaps someone can verify this.