DSCN0224.JPG
I was not a fan of the 'clip in' style servo mounts used on the car, as it required the top brace which was held in with six screws (a nightmare when it comes to maintenance) so I decided to put in some AE servo mounts. These however move the servo forwards by about 1cm, so the upper servo saver was fouling the servo case. I dremeled the end of the saver off and had to chop some of the ballstud off.
DSCN0226.JPG
It just makes it now, not much room at all!
DSCN0227.JPG
The lack of that top brace will also free it up a bit and give some flex.