Well thanks to Ron I have just received a zx5 rear of front gearbox pivot block. Ok its too big for that however something that I did notice is that it will fit behind the motor in the pivot block position there with a spacer underneath and upside down. Ok you will need the relevant pivot pole balls that slide on over the pole but appears to be roughly a mm longer than the usual one we use but if an issue arises where you need something to use as an emergency then keep this in mind.
Also I will be having a couple of pivot block designs made up as a proto and if sufficient I will be trying to get a batch made in plastic and see how it goes, I am beefing up the front behind gearbox design and the one behind the motor. If my thoughts on this work then I will have a large batch made up and will supply to whoever needs them as and when needed. As always it takes time but the plan is to get something roughly made in March and take it from there.
|